Under KVM (proxmox) no IPv4 at eth0(virtio)

Support
1

Good afternoon,
only want to report an anomaly / nethserver6.6

  • Create a VM under proxmox for nethserver6.6.
  • 2 x LAN (virtio) green 192.168…
  • install nethserver6.6.
  • after install at the nethserver terminal call "ifconfig"
    only see IPv6 address ! not the IPv4 192.168…
  • I tried this 3 times > the same result
  • then changed type of eth0 from virtio to intel1000 > reboot
  • NOW THERE IS IPv4 192.168…
    Is there a bug inside nethserver-drivers ??
    It’s not a big problem, but I wonder why ?

Thank you for reading this …

2

Ok i could test this :slight_smile:

3

Dear, i have added new VirtIO network card :
Dmesg

virtio-pci 0000:00:15.0: irq 24 for MSI/MSI-X
alloc irq_desc for 25 on node -1
alloc kstat_irqs on node -1
virtio-pci 0000:00:15.0: irq 25 for MSI/MSI-X
alloc irq_desc for 26 on node -1
alloc kstat_irqs on node -1
virtio-pci 0000:00:15.0: irq 26 for MSI/MSI-X

Lspci

00:14.0 Ethernet controller: Intel Corporation 82540EM Gigabit Ethernet Controller (rev 03)
00:15.0 Ethernet controller: Red Hat, Inc Virtio network device