OpenVPN site2site and roadwarriors simultaneously

Support
1

Hello folks,

How can one have these two models working together on the same server?

Best regards,

2

You configure the Roadwarrior using the UI and once that is done, place your own site2site OpenVPN conf file, assuming that NS is the ā€œclientā€ side, in the /etc/openvpn directory. Iā€™m not sure if this is how it would also work if NS is the server side though, as I only run a VPN client alongside Roadwarrior. NS will then start/stop both configurations at the same time.

Cheers.

1 Like
3

Hi EddieA,

Thanks for the reply!

I was able to have everything functioning via command line.
I had to manually edit and add all the configs, which I didnā€™t wanted that way, cause on my first attempt to change a little detail on the GUI broke everything.

The problems I had:

  1. I want the NS to be as the server side. The other side uses a dynamic IP address.
  2. For this to work OpenVPN needs to use different ports. So I had to open them via ā€˜config setpropā€™.
    (How do you open a range of ports?)
  3. Since I have many users I also want them to be connected at the same time.

Best regards,