ohifra
(Francesco)
June 4, 2018, 9:53am
1
NethServer Version: your_version
Module: your_module
Hi, I just upgraded to email2 with the command:
yum swap \
- remove nethserver-mail- {common, disclaimer, filter, server} nethserver-getmail nethserver-spamd \
- install nethserver-mail2- {common, disclaimer, filter, server, getmail}
Nethserver works fine but from the administrative panel the menu for creating / editing new pop3s / imap connectors has disappeared.
From the software center it does not let me install the “POP3 Connector” module because it gives me error:
Resolving RPM dependencies
The update / installation command may have failed due to problems in the metadata cache. Clean the cache by clicking on the button below and repeat the installation / update operation.
Many thanks in advance
ohifra
(Francesco)
June 4, 2018, 9:56am
2
Fixed, it was enough to clear the cache twice.
Now everything is OK
2 Likes
davidep
(Davide Principi)
June 4, 2018, 9:57am
3
You probably picked the wrong procedure. The correct command depends on what you installed. If you run the pop3 connector this one is for you
http://docs.nethserver.org/en/v7/mail2.html#from-pop3-connector-module
Try to issue again that command, and report back its output here, thanks.
ohifra:
yum swap
- remove nethserver-mail- {common, disclaimer, filter, server} nethserver-getmail nethserver-spamd
- install nethserver-mail2- {common, disclaimer, filter, server, getmail}
@davidep , Francesco did the command for the pop 3 connector, I think this is the right one
@ohifra Could you mark it as solved please
Now we have an amazing feature on our community platform which helps to mark a topic as SOLVED
As the OP (topic creator) you will have a button that allows you to accept an answer
[image]
Accepted answers are highlighted in the topic list:
[image]
Accepted answers are highlighted on the initial topic:
[image]
This kind of action is enabled only for topic into the Support category
Happy support!
1 Like