Hi NethSecurity, Install on Proxmox: Installation — NethSecurity documentation . root@pve-1:/temp# qm importdisk 401 nethsecurity-23.05.0-x86-64-generic-squashfs-combined-efi.img.gz local-lvm Gives error: nethsecurity-23.05.0-x86-64-generic-squashfs-combined-efi.img.gz: non-existent or non-regul…

Victory ! [image] Michel-André

Hello, about this alpha, i tried to test on proxmox but the IMG wont boot. (No bootable device) I tried import as a disk and as a CD IMG. Both import wont boot. Any suggestion? Thanks

Did you enable the scsi0 device in the proxmox vm boot options?

Hi @sarz4fun As I wrote above, there is an error in the documentation; there is no .gz at the end of the image name in the qm command. [image] michelandre: It should be with no .gz ? qm importdisk 401 nethsecurity-23.05.0-x86-64-generic-squashfs-combined-efi.img local-lvm Michel-André P.…

Hi NethSecurity, Also, why taking port 443 to access the manager page ??? Then after that how do you want to redirect port 443 to the webserver of another server ??? Errare humanum est, perseverare diabolicum You can also access another “manager page” with: https://ip-address/cgi-bin/luci/ . Mi…

Hi NethSecurity, Installation — NethSecurity documentation . By default, the network configuration will be as follows: The LAN interface will be configured with a static IP address of 192.168.1.1. The WAN interface will be configured to use DHCP to obtain an IP address from your ISP. Developer…

Did you use 401 as VM ID? If the answer is no you need to change the VM ID in the other commands too. Do you have two network interfaces in your Proxmox server? I followed the installation steps for proxmox (except of the appended .gz part) and it worked, so maybe one of the commands failed on you…

The only difference Is my storage: local-zfs instead of local-lvm. I think that i can’t import the image on zfs block storage… Maybe i have to dd the image… I Will try again later.

[image] michelandre: It should be with no .gz ? qm importdisk 401 nethsecurity-23.05.0-x86-64-generic-squashfs-combined-efi.img local-lvm Thank you for pointing it out, I’ve fixed the doc. [image] michelandre: Also, why taking port 443 to access the manager page ??? Then after that how…

NethServer Community

NethSecurity Install on Proxmox shield (doc error)

NethSecurity

error

show post in topic

Home
Categories
Guidelines
Terms of Service
Privacy Policy

Powered by Discourse, best viewed with JavaScript enabled